Trueline Drainage Solutions

Pitch Fibre Drains: What They Are and How They Fail

Pitch fibre drains were widely laid in homes built after the Second World War, particularly on estates from the 1950s to the 1970s. The material was light, cheap and quick to install. Decades later, many of those pipes are reaching the point where they lose their shape, and that change is behind a lot of repeat blockages in houses of that era.

Request a free quote

By sending this form you agree to our privacy policy.

TrustATrader vetted and approved5.0 rating on TrustATraderCheckatrade memberCheckatrade £1,000 guarantee (T&Cs apply)24/7 emergency calloutDomestic and commercialTrustATrader vetted and approved5.0 rating on TrustATraderCheckatrade memberCheckatrade £1,000 guarantee (T&Cs apply)24/7 emergency calloutDomestic and commercial

Written by George Piper, Trueline Drainage Solutions ·

What is pitch fibre pipe?

Pitch fibre pipe is made from wood or cellulose fibres bound together and soaked in coal tar pitch. It was used for underground drainage and some sewer pipes because it was easy to handle and cut, and joined with simple tapered couplings. It is usually black, with a slightly soft, almost cardboard-like texture compared with clay or plastic.

How do I know if I have pitch fibre drains?

Age is the first clue. A house built roughly between the late 1940s and the early 1980s, especially on a planned estate, may have pitch fibre drainage. Lift an inspection chamber cover and look at the pipe ends where they enter the chamber. Black pipe with a flaky or fibrous edge, rather than glazed clay or smooth plastic, suggests pitch fibre.

Many runs were later partly repaired or replaced, so one chamber is not proof for the whole system. A camera inspection shows the material along each length and where it changes.

How pitch fibre fails

Over time, the weight of the soil above and the warmth of hot water can make the pipe soften and sag. The most familiar fault is ovality, where the round pipe flattens into an oval. Another is blistering or delamination, where the inner layers lift and form bubbles that catch paper and debris. In bad cases the pipe can collapse completely.

Hot discharges from washing machines and dishwashers, and some strong chemicals, can speed up this softening. The result is often a drain that blocks again and again in the same spot, however well it is cleared.

Why a survey comes first

Because the faults are inside the pipe, a CCTV drain survey is the starting point. It records the material, how much the pipe has deformed, any blisters and the length affected. That information decides whether a lining can be installed or whether the pipe has lost too much shape and needs replacing.

Be careful with aggressive cleaning on pitch fibre. Blisters and softened walls need a method chosen for the material, not the same approach used on clay.

Repair options usually considered

Where the pipe has deformed but still holds enough shape, it can sometimes be re-rounded with specialist tools and then lined. Drain relining puts a new resin-hardened pipe inside the old one, which avoids digging up gardens and driveways. Where a length has collapsed or is too flattened, that section may need excavation and replacement with modern plastic pipe.

Many runs combine both: a short section is replaced and the remainder is lined.

What affects pitch fibre drain repair cost

Costs depend on the length affected, how badly the pipe is deformed, whether re-rounding is possible, the pipe diameter, access to chambers and what lies above any section that must be dug out. A lawn and a block-paved driveway are very different to excavate. The survey findings are what turn those factors into an accurate quote.

Need it sorted? Book drain relining

If your drain keeps blocking and the property dates from the post-war decades, ask about drain relining after a camera inspection. Call 0333 335 7414, message 07428 535083 on WhatsApp or request a quote. Mention the age of the house, any previous survey and how often the drain blocks.

Want a professional to handle it?

Tell George about the problem using the enquiry form below.

Frequently asked questions

What is pitch fibre pipe?

A drainage pipe made from wood or cellulose fibres soaked in coal tar pitch. It was common in post-war housing because it was light and easy to lay.

How do I know if I have pitch fibre drains?

Homes built from the late 1940s to the early 1980s are the likeliest. Black, fibrous pipe ends in an inspection chamber suggest it, and a camera survey confirms the material along each run.

Can pitch fibre drains be relined?

Often, if the pipe still holds enough shape or can be re-rounded first. Severely flattened or collapsed sections usually need replacing before the rest is lined.

Why does my pitch fibre drain keep blocking in the same place?

A flattened section or a blister narrows the pipe and catches waste. Clearing it restores flow for a while, but the restriction remains until the pipe is repaired.

Related

Related services

Need a drainage problem sorted?

Speak to George directly for honest advice and a clear quote.

Request a free quote

By sending this form you agree to our privacy policy.

Call nowGet a quote