Why is my sink draining slowly?
In a kitchen, the usual cause is fat. Warm grease from pans and plates runs down the plughole as a liquid, cools in the pipe and sticks to the walls. Food scraps and coffee grounds catch on it, and the opening gets smaller with every wash-up. Dishwashers and washing machines often share the same waste pipe, adding detergent residue and lint.
In a bathroom basin, hair and soap do the same job. Toothpaste, shaving foam and cosmetics bind the hair into a mat around the plug linkage or in the trap.
Less often, the cause is the pipe itself: a waste run with too little fall, a sag where a pipe has dropped, or a vent that is missing so air cannot get in behind the water.
One sink or the whole house?
This is the most useful question to answer. If only one sink is slow and everything else drains well, the restriction is in that sink's trap or its own short waste pipe. If the kitchen sink, the downstairs toilet and the shower all slow down together, the problem is further along, in a shared pipe or the main drain outside.
Look at the outside gully or the nearest inspection chamber while the sink drains. A gully that fills and overflows points to the pipe beyond it. A sink that gurgles as it empties often has a partial blockage downstream; our guide to gurgling drains explains how to read those noises.
What you can safely try
Remove and clean the plug or strainer. Place a bowl under the trap, unscrew it by hand and clear out what has collected inside. Refit it hand-tight and check for drips. A sink plunger, with the overflow covered by a damp cloth, can shift a soft clog just below the trap.
Avoid pouring strong chemical cleaners into standing water. They may not reach the blockage, they make any later work unpleasant and they can harm some plastic fittings.
How to fix a slow draining kitchen sink properly
If cleaning the trap does not help, the build-up is in the waste pipe through the wall or the underground branch to the drain. Rods can punch a hole through grease, but the coating usually remains and the sink slows again. Jetting removes the layer from the full bore of the pipe. Our blocked kitchen sink drain page covers how that is done.
For basins, see blocked bathroom sink, which deals with hair, pop-up wastes and long horizontal runs.
Fixing slow draining throughout the house
When several fittings are slow, focus on the shared drain rather than each sink. Clearing the main line and then checking it by camera shows whether a root, a displaced joint or a dip is collecting debris. Fixing that one defect restores flow to every fitting that depends on it.
Stopping it coming back
Wipe greasy pans with kitchen roll before washing them, scrape plates into the bin and use a strainer in the plughole. In bathrooms, a simple hair catcher saves a lot of trouble. Running plenty of hot water after the last wash-up of the day helps carry residue through.
Need it sorted? Book blocked kitchen sink drain clearance
If your sink is still slow after the trap has been cleaned, book blocked kitchen sink drain clearance. Call 0333 335 7414, message 07428 535083 on WhatsApp or send the quote form saying which sinks are affected.
Want a professional to handle it?
Tell George about the problem using the enquiry form below.
Frequently asked questions
How do you fix a slow draining kitchen sink?
Clean the trap first. If that does not help, the grease is further along the waste pipe and usually needs jetting to remove the coating from the pipe walls.
How do you fix slow draining drains in the whole house?
Treat it as a main drain problem. Clear the shared pipe, then check it with a camera so any defect that is catching debris can be repaired.
Can a dishwasher make a sink drain slowly?
It can add food particles and detergent residue to a shared waste pipe. A poorly fitted connection can also push water back into the sink.
Is a slow sink an emergency?
Usually not, but it is a sign that a full blockage is coming. Dealing with it early is simpler and avoids overflowing when you least expect it.
