What a soakaway does and where it is used
Most domestic soakaways take surface water: rain from a roof, a patio, a garden or a driveway. Older ones are often a hole filled with brick rubble; modern versions usually use plastic crates wrapped in a geotextile membrane, which hold far more water for their size and keep soil from washing in.
People sometimes search for a soakaway for a septic tank. That is a different system, normally called a drainage field, and it handles treated effluent rather than clean rainwater. The rules around it are stricter, so in most cases you should check with the Environment Agency and building control before anything changes. We will tell you honestly if your situation falls into that category.
Checks before anything is dug
A soakaway only works if the ground can take the water. Clay soils drain slowly, chalk and gravel much faster, and a high water table can make a pit useless in winter. Soakaway testing, often called a percolation test, means digging a trial hole, filling it with water and timing how fast the level drops. The result is what the size of the soakaway is worked out from.
Position matters as much as size. Building guidance usually expects a soakaway to sit a sensible distance from the house and other foundations so water is not dumped next to them. We also trace the pipe that will feed it with a camera and locating sonde, using our drain tracing and mapping equipment, so the new chamber lines up with the downpipes it serves.
Replacing an old or failed soakaway
When an existing pit has silted up or collapsed, the usual answer is to dig out the old material, find out why it failed and build a new one, sometimes in a better spot. Before that step, it is worth ruling out a simpler fault: plenty of soakaways that seem dead are just being starved by a blocked feed pipe. Our soakaway unblocking page covers that diagnosis.
Where digging is involved, the work runs much like our drain excavation jobs: careful breaking out, a clean trench, new pipework laid to the correct fall and the ground or surface reinstated afterwards.
Soakaways on driveways and in gardens
A soakaway under a driveway has to take the weight of cars, so the crates, cover depth and surface above all need to suit traffic. In a garden there is more freedom, but tree roots, sheds and future extensions all affect where the chamber should go. If you are planning building work nearby, mention it early so the soakaway does not end up in the way.
What affects soakaway cost
We do not publish set prices because the job varies so much. The main factors are the size needed after testing, how much digging and spoil removal is involved, access for equipment, what surface has to be lifted and relaid, and how much new pipework runs to it. You get a clear quote once the ground and drains have been looked at.
Frequently asked questions
Can soakaways cause subsidence?
A soakaway placed too close to a building can soften the ground under the foundations, which is why distance from the house matters. Positioned and sized correctly, it should not cause a problem.
What is soakaway testing?
It is a percolation test: a trial hole is filled with water and the rate it drains away is measured. That figure is used to work out how large the soakaway needs to be.
How do you replace a soakaway?
The failed pit is dug out, the cause is checked, and a new chamber, usually crates in a membrane, is installed and connected to the existing pipework before the surface is reinstated.
Can a soakaway take water from the house drains?
No. A rainwater soakaway is for surface water only. Foul water from toilets, sinks and showers must go to the sewer or a treatment system.
